Australian-monitor AMC+MIX Bedienungsanleitung

INSTALLATION AND OPERATION MANUALAMC+ MIX

Frequency Response 20Hz - 20kHz (+0,-3dB)Total Harmonic Distortion < 0.5% @ 1kHzSignal To Noise Ratio > 84dB (all pots at centre pos

PAGE 11AMC+ MIX INSTALLATION AND OPERATION MANUALNOTES

ENGINEERED BY AUSTRALIAN MONITOR Address: 1 Clyde Street, Silverwater, Sydney NSW 2128 Australia. Private Bag 149, Silverwater NSW 1811 ACN 007 573 4

1. Save the carton and packing material even if the equipment has arrived in good condition. Should you ever need to ship the unit, use only the orig

AMC+ MIX The Australian Monitor AMC+ Mix mixer takes the affordability and ease of use of our AMC+ series amplifiers and integrates the front end into

1 CH 1–4These control the levels for each channel input.2 BassThere is 12dB of cut and boost at 100Hz.3 TrebleThere is 9dB of cut and boost at 10kHz.

1236451 CH 1–4Each channel input section has two inputs: XLR input – This is a balanced microphone input. It has an input sensitivity of 1mV. RCA inp

MountingYour amplifier is designed for standard 19” rack mounting and occupies 2 EIA rackunits (3.5”). The mounting centres are: Vertical: 1.5” (38.1mm

TROUBLESHOOTING GUIDETrouble Likely Cause Remedy Power LED not on Check power switch is on Check plug pack connectionDistorted sound Input is overl

PriorityChannel 1 will mute channels 2, 3 and 4. This will only occur when signal appears on channel 1, irrespective of the channel volume control. Pr

PAGE 9AMC+ MIX INSTALLATION AND OPERATION MANUALDIMENSIONS