AUSTRALIAN MONITOR AV2.2P Spezifikationen

AV2.2PDual Channel Audio AmplifierInstallation Operation Manual&Status BStatus A PowerAV2.2P

+ 2.2 dBu (1.0 Volts) for rated Power into a 4 ohm load.The signal source (i.e. the equipment feeding signal to the amplifier) should have anof 600 Oh

Operation 11NOTEIf the input ground lift switch is used, you must ensure adequate shielding of the input wiring. If the signal sourceequipment does no

6. MAINTENANCEOnly or persons should attempt any service or maintenance of the amplifier.The surface of the Heat Sink may become covered with dust ove

Dimensions 137. DIMENSIONS467.0 mm482.0 mm32.0 mm44.0 mm442.0 mm283.5 mm16.0 mmStatus BStatus A PowerAV2.2PBALANCED INPUTBALANCED INPUTPUSH TOPUSH TOO

14 Block Diagram8. BLOCK DIAGRAMONONOFFOFF22E22EO/P (A) Current limitO/P (B) Current limitAV2.2P

Specifications 159. SPECIFICATIONSOutput Power (Per channel at 4 ohms) 0.1% THDSingle Channel driven : 120WBoth/All Channels driven : 100W(2 ohm loads

Sydney(NSW & ACT Sales)Melbourne(Vic & Tas Sales)Brisbane(Qld Sales)Adelaide(SA & NT Sales)Perth(WA Sales)Auckland(NZ Sales)Private Bag 14

CAUTIONRISK OF ELECTRIC SHOCKDO NOT OPENCAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK.DO NOT REMOVE COVER (OR BACK).NO USER-SERVICEABLE PARTS INSIDE.R

CONTENTSSection Page No.1. Introduction 42. Front Panel 53. Back Panel 64. Installation 75. Operation 96 Maintenance 127. Dimensions 138. Block Diagra

1. INTRODUCTIONThe AMAV AV2.2P isa1RUstereo power amplifier. Designed for the demanding commercial audio-visualmarket, the AV2.2P delivers 100 watts p

2. FRONT PANEL1. Status Indicators for Channels A and B2. Power ON indicator3. Attenuators for Channels A and B4. Power ON Switch5. Rack EarsThese are

3. BACK PANEL1. Balanced Input (Channel-A)2.3. Signal GND Lift switchThe amplifier should be turned off before engaging thisswitch!4. Bridge SwitchThe

Installation 74. INSTALLATIONPower RequirementsMountingPower consumption for your model AV2.2P amplifier is indicated on the rear panel for maximum ou

When wiring for an unbalanced source:Pin 1 =GROUND/SHIELD,Pin 2 = HOT (in phase with the amplifier’s output),Pin 3 = GROUND/SHIELD (joins to pin 1).In

Operation 95. OPERATIONIMPORTANTyourmay be youBefore making any connectionsBefore operatingAll signal source equipment should be adequately earthed. T