Australian-monitor DPRM Bedienungsanleitung PDF herunterladen (Seite 5)

DPRM INSTALLATION & OPERATION MANUAL PAGE 5

INSTALLATION

The CAT5 cable connects to the screw terminals numbered 1-6. These

numbers correspond to the pins of the RJ45 connector on the main

unit. If following the 568A convention, the wire colours are wired as:

PIN WIRE COLOUR DP NETWORK

1 White/Green Ground

2 Green +18V

3 White/Orange Data+

4 Blue Busy-

5 White/Blue Busy+ (+18V)

6 Orange Data-

7 White/Brown Spare

8 Brown Spare

Ensure that the spare pair cannot short to anything.

NOTE: If the Remote Control Panel is NOT the last

unit in the CAT5 RUN and there are paging stations

connected further down the run it is important that

the spare pair is continued to the next unit otherwise

voice information from the paging stations will not

get to the main DigiPage unit.

There are two holes available adjacent to the terminal block for

securing the CAT5 cable with a cable tie.

“PIN 1”

☛

1 2 3 4 5 6 7 8

Keine Kommentare

Australian-monitor DPRM Bedienungsanleitung Seite 5